Author Topic: Question about Gizduino Board ATmega168. (Read 780 times)

xyzled · « **on:** October 02, 2010, 03:52:21 PM »

Hi, we just bought an Arduino board (Gizduino ATmega168). At first we programmed it and our first try worked using a 5V from USB cable as power input.. But when we tried it again, it's not functioning, only the green LED turned on and the orange LED does not turn on.

I just want to ask if anyone knows what is the possible problem? Did anybody encountered this problem already? Thanks

Philippine Electronics Forum · « **on:** October 02, 2010, 03:52:21 PM »

0b00000111 · « **Reply #1 on:** November 20, 2010, 04:04:29 PM »

yes naranasan ko ito kanina.. workaround:

press and hold reset... press upload sa Arduino IDE, if nakita mo ito: Binary sketch size: xxx bytes (of a xxx byte maximum)... be ready to release (but do not release yet the reset)... if nagscroll na siya, immediately release the reset...

Philippine Electronics Forum · « **Reply #1 on:** November 20, 2010, 04:04:29 PM »

OPTIMUS PRIME · « **Reply #2 on:** November 20, 2010, 04:45:41 PM »

bossing diba sa hex ng bootloader yan...mukha may nabasa ako sa arduino site...ala lang ako pang reprogram ng bootloader

Philippine Electronics Forum · « **Reply #2 on:** November 20, 2010, 04:45:41 PM »

0b00000111 · « **Reply #3 on:** November 20, 2010, 05:14:50 PM »

may nabasa din ako na issue daw sa bootloader... wala din akong pang reprogram ng bootloader.. pero ok lang, I can live with this naman hehehe.. as long as narereprogram ko, everything is ok with me heheheh

Philippine Electronics Forum · « **Reply #3 on:** November 20, 2010, 05:14:50 PM »

tiktak · « **Reply #4 on:** November 20, 2010, 05:22:18 PM »

ayos pala magkaproblema man ako sa gizduino ko may pang reprogram naman ako ng bootloader

Philippine Electronics Forum · « **Reply #4 on:** November 20, 2010, 05:22:18 PM »

anthonydp · « **Reply #5 on:** November 20, 2010, 05:52:39 PM »

puedeng gamitin na pang-reprogram ng bootloader ang isa pang arduino gamit ang ArduinoISP sketch sa Files>Examples>ArduinoISP

Then, Tools>Burn Bootloader>w/ Arduino as ISP

Yung gagamitin nyang bootloader firmware ay yung para sa board na na-select mo from Tools>Board

Philippine Electronics Forum · « **Reply #5 on:** November 20, 2010, 05:52:39 PM »

Philippine Electronics Forum