Author Topic: PROTOTYPE OF OUR THESIS VENDING MACHINE (Read 534 times)

prenziboi · « **on:** October 29, 2010, 09:29:16 AM »

kanino po pede magpatulong or magpagawa dito ng prototype namin sa thesis.
"prototype design of cooking oil vending machine with temperature controller"
ang gagamitin po ay PLC.......

tnx !

Philippine Electronics Forum · « **on:** October 29, 2010, 09:29:16 AM »

insomartin · « **Reply #1 on:** October 29, 2010, 09:44:55 AM »

punta ka nang e-gizmo tomorrow. 1pm to 5pm. tulungan ka namin.

Philippine Electronics Forum · « **Reply #1 on:** October 29, 2010, 09:44:55 AM »

glutnix_neo · « **Reply #2 on:** October 29, 2010, 09:57:06 AM »

naku, mahal kaya ang PLC

Philippine Electronics Forum · « **Reply #2 on:** October 29, 2010, 09:57:06 AM »

insomartin · « **Reply #3 on:** October 29, 2010, 10:02:10 AM »

Quote from: glutnix_neo on October 29, 2010, 09:57:06 AM

naku, mahal kaya ang PLC

anong ginagawa nang **micro...

Philippine Electronics Forum · « **Reply #3 on:** October 29, 2010, 10:02:10 AM »

glutnix_neo · « **Reply #4 on:** October 29, 2010, 10:05:12 AM »

pero paano kung PLC ang required talagang gamitin?

Philippine Electronics Forum · « **Reply #4 on:** October 29, 2010, 10:05:12 AM »

insomartin · « **Reply #5 on:** October 29, 2010, 10:28:38 AM »

^ ayun lang.
at lease may second hand na plc sa gizmo.

prenziboi · « **Reply #6 on:** October 29, 2010, 05:22:31 PM »

san po yung e-gizmo? sino po pede magbigay dito ng contact number...
plz........

glutnix_neo · « **Reply #7 on:** October 29, 2010, 08:32:13 PM »

E-Gizmo
2nd Floor VSC Building, 2313 Taft Ave. cor Castro St., Malate, Manila

http://e-gizmo.com/

Philippine Electronics Forum · « **Reply #7 on:** October 29, 2010, 08:32:13 PM »

Philippine Electronics Forum