Author Topic: double sided pcbboard... (Read 576 times)

markmiravalles · « **on:** March 21, 2011, 04:18:28 AM »

mga masters pano ba mag unsolder ng ic, transistor at mga cmponents na madaming paa sa double sided na pcb..na hindi nasisira ang tracks ng printed copper..advice naman po dyan..

Philippine Electronics Forum · « **on:** March 21, 2011, 04:18:28 AM »

insomartin · « **Reply #1 on:** March 21, 2011, 04:55:16 AM »

i flood mo yung component nang lead. then taktak method. dapat mabilis ka.

Philippine Electronics Forum · « **Reply #1 on:** March 21, 2011, 04:55:16 AM »

danny · « **Reply #2 on:** March 21, 2011, 05:44:16 AM »

or pwede ka din gumamit ng tweezer
kung nde mo type yung tak-tak method

kung my chip-quick ka mas ok
may kamahalan nga lang

Philippine Electronics Forum · « **Reply #2 on:** March 21, 2011, 05:44:16 AM »

amadjo01 · « **Reply #3 on:** March 21, 2011, 09:12:47 AM »

hot air tapos taktak method, kaso mahal ang hot air....

Philippine Electronics Forum · « **Reply #3 on:** March 21, 2011, 09:12:47 AM »

markmiravalles · « **Reply #4 on:** March 21, 2011, 08:22:43 PM »

ano po ba ang chip quick?

Philippine Electronics Forum · « **Reply #4 on:** March 21, 2011, 08:22:43 PM »

??? · « **Reply #5 on:** March 21, 2011, 08:42:06 PM »

Pwede rin yung solder iron with pump yung maliit lang tapos circling motion sa paa ng mga IC, kung yung malilit at maraming paa na nakadikit lang sa board, hot air tapos flood ng flo.

rdpzycho · « **Reply #6 on:** March 21, 2011, 09:56:12 PM »

kung mabilis kumilos, punuin ng tingga, tulad ng sabi ni Boss Martin, tapos hila ng component.

Mayalin22 · « **Reply #7 on:** March 21, 2011, 10:10:36 PM »

kung DIL package... cut na lang pins.. saka mo alisin isa-isa... mahirap masiraan ng double sided

Philippine Electronics Forum · « **Reply #7 on:** March 21, 2011, 10:10:36 PM »

Philippine Electronics Forum