Author Topic: Connections, Materias etc (Read 142 times)

momokakase · « **on:** August 01, 2011, 11:28:25 PM »

Yung topic ko po kasi ay about automated electric fan... Na sesense niya po yung temperature tapos depende dun yung lakas ng fan niya... Tapos pag sobrng lamig po ng temp dun sa room, automaticaly mag turn off na pos iya.

Ang mga gagamitin ko po ay Arduino tapos LM35 para dun sa temperature sensor..

Ang hindi ko po maiisip kung pano ikakabit yung controller sa E-fan.. Saka kung pano po yung supply niya?

Philippine Electronics Forum · « **on:** August 01, 2011, 11:28:25 PM »

Macgyver · « **Reply #1 on:** August 01, 2011, 11:30:52 PM »

kakabit mo sa relay

Philippine Electronics Forum · « **Reply #1 on:** August 01, 2011, 11:30:52 PM »

momokakase · « **Reply #2 on:** August 02, 2011, 06:54:31 AM »

Eh yung input po sa Arduino na power? Pano po yun?

Philippine Electronics Forum · « **Reply #2 on:** August 02, 2011, 06:54:31 AM »

momokakase · « **Reply #3 on:** August 02, 2011, 06:58:47 AM »

Saka kailangan ko pa po ba idesign yung e-fan ko. O pwede nang i modify nalang yung existing e-fan

Philippine Electronics Forum · « **Reply #3 on:** August 02, 2011, 06:58:47 AM »

Macgyver · « **Reply #4 on:** August 02, 2011, 07:43:41 AM »

Ganito gawin mo

http://www.glacialwanderer.com/hobbyrobotics/?p=9

Philippine Electronics Forum · « **Reply #4 on:** August 02, 2011, 07:43:41 AM »

Philippine Electronics Forum