Author Topic: infrared remote switch using an ordinary tv remote and detector? (Read 600 times)

nympha · « **on:** September 18, 2011, 04:22:04 PM »

mga sir. ask lng po ako ng schematic or any other references regarding ir remote controller for appliances. Uisng the relay as switches. gaya po nito >>

infrared remote switch using an ordinary tv remote and detector?

Philippine Electronics Forum · « **on:** September 18, 2011, 04:22:04 PM »

SpongeBob · « **Reply #1 on:** November 03, 2011, 07:18:38 PM »

http://www.electronicslab.ph/forum/index.php?topic=6399.0

Meron na source code. Pwede ko rin i-port sa ibang mcu at gawin open source project basta may magbigay ng pinaglumaan na development board.

Philippine Electronics Forum · « **Reply #1 on:** November 03, 2011, 07:18:38 PM »

sgboy · « **Reply #2 on:** November 03, 2011, 08:40:16 PM »

watch your video carefully. you will get what you need.

Philippine Electronics Forum · « **Reply #2 on:** November 03, 2011, 08:40:16 PM »

SpongeBob · « **Reply #3 on:** November 03, 2011, 10:47:19 PM »

Kung isang relay lang iko-control pwede na LM555 wired as missing pulse detector and flip-flop.

Philippine Electronics Forum · « **Reply #3 on:** November 03, 2011, 10:47:19 PM »

bravokilo · « **Reply #4 on:** November 04, 2011, 10:34:49 AM »

If you
want to be fully secured, you have to use an encoder/decoder IC such as the mcu145030. There are 512 addresses.....hook it up sa infra tx and Rx.

BK

Philippine Electronics Forum · « **Reply #4 on:** November 04, 2011, 10:34:49 AM »

Philippine Electronics Forum