Author Topic: MikroC COF file and Proteus Simulation Problem (Read 644 times)

toasted siopao · « **on:** February 04, 2012, 10:19:08 AM »

MikroC generates COF file that is incompatible with Proteus as it has no config fuses, so di sya pwede i-debug sa Proteus.

Anyway here is the link regarding the issue, http://www.mikroe.com/forum/viewtopic.php?f=88&t=23806&hilit=cof+isis.

Philippine Electronics Forum · « **on:** February 04, 2012, 10:19:08 AM »

carlsberg11 · « **Reply #1 on:** February 04, 2012, 05:16:39 PM »

Quote from: toasted siopao on February 04, 2012, 10:19:08 AM

MikroC generates COF file that is incompatible with Proteus as it has no config fuses, so di sya pwede i-debug sa Proteus.

Anyway here is the link regarding the issue, http://www.mikroe.com/forum/viewtopic.php?f=88&t=23806&hilit=cof+isis.

ito ata solution sa problema ko sir! maraming salamat po dito! +1 ka po

Philippine Electronics Forum · « **Reply #1 on:** February 04, 2012, 05:16:39 PM »

alameen13 · « **Reply #2 on:** February 16, 2012, 12:56:19 AM »

thanks

Philippine Electronics Forum · « **Reply #2 on:** February 16, 2012, 12:56:19 AM »

dummy_c · « **Reply #3 on:** February 16, 2012, 06:37:49 AM »

Wow ngayon ko lang nabasa to. +1 master moderator.
Nakakatulong din ang pag spam ni alameen13.

By the way na experience ko rin ito when nag hardware debug ako using Pickit2+MPLAB+MikroC cof file+PIC.
Wala din sa cof file ang config settings.
Ang ginawa ko import ko muna ang hex file then after that import ko ang cof file.
Pwedi rin manual config settings sa MPLAB.

Philippine Electronics Forum · « **Reply #3 on:** February 16, 2012, 06:37:49 AM »

Philippine Electronics Forum