Author Topic: [HELP] - 74ls193 Binary Counter (Read 1166 times)

FarProd · « **on:** February 07, 2012, 10:11:23 AM »

Paano po ba i design 74ls193 na mag ka-count up and count down ang 74ls193 Binary Counter to Binary Coded Decimal (BCD) 00 - 99 and 99-00?

any help..

Sana eh, mabigyan niyo ako ng schematic diagram... Thanks a lot!

Philippine Electronics Forum · « **on:** February 07, 2012, 10:11:23 AM »

yhangel_07 · « **Reply #1 on:** March 01, 2012, 11:50:58 AM »

eto yung data sheet ng 74193

[

Pin 16= +source
8= - source
2,3,6,7= to Display
4 or 5= Clock pulse

pag count down sa 4
pag count up sa 5

Philippine Electronics Forum · « **Reply #1 on:** March 01, 2012, 11:50:58 AM »

Interlock() · « **Reply #2 on:** March 01, 2012, 01:11:39 PM »

^nasa datasheet po ang sagot sis...
e2 inihanap na rin kita...
http://www.datasheetcatalog.org/datasheets/90/248169_DS.pdf

Philippine Electronics Forum · « **Reply #2 on:** March 01, 2012, 01:11:39 PM »

partyshaker · « **Reply #3 on:** March 01, 2012, 10:09:45 PM »

ito 00-99 up counter. kaw na bahala mag hanap ng paraan panu mo ibaba yan.

Philippine Electronics Forum · « **Reply #3 on:** March 01, 2012, 10:09:45 PM »

Interlock() · « **Reply #4 on:** March 02, 2012, 08:25:23 AM »

^haha! kunsintidor!

Philippine Electronics Forum · « **Reply #4 on:** March 02, 2012, 08:25:23 AM »

partyshaker · « **Reply #5 on:** March 02, 2012, 12:48:05 PM »

hahahaha...humihingi eh. e di bigyan.
nasa kanya naman yan kung gusto nyang matoto o hindi.

dummy_c · « **Reply #6 on:** March 02, 2012, 01:16:08 PM »

I miss the time when I played with logic gates and counters.
Anyway parang hindi masyadong mahirap yan dahil BCD lang daw ang output.
So no need na ang 7447 at 7 segments.
Ok na yang binigay ni jjepoy. Hindi yan manual up counter.
Gawan mo lang TS ng two way switch sa UP/DN input ng 193 sa one's digit.
Then detect mo ang 0 to 9 transistion sa CO pin ng ones digit connect mo sa DN pin ng tens digit.
You may need to invert the signal, kaw na bahala mag experiment.

motion55 · « **Reply #7 on:** March 02, 2012, 04:54:01 PM »

Sa down count naman, since you were asked to use a 74LS193 binary counter, you need to detect the "borrow" signal and load the value "9" to the 74LS193 counter.

dummy_c · « **Reply #8 on:** March 02, 2012, 06:14:18 PM »

Ay so sory TS, mali pala ang sabi ko.
Detect 0-9 transition sa BO pin.
I stand corrected.
Thanks sir motion.

lito2012 · « **Reply #9 on:** March 03, 2012, 04:37:07 PM »

Please help me my project LED scoreboard 3 digits manual up and down. Sino po meron na pakibigay naman ng schematic diagram.

yhangel_07 · « **Reply #10 on:** March 03, 2012, 10:56:56 PM »

lito2012.. gawa ka muna schem tska ka tulungan ng mga master.. hehe.. gnun din akin ehh.. natuto ako.. =P

Philippine Electronics Forum · « **Reply #10 on:** March 03, 2012, 10:56:56 PM »

Philippine Electronics Forum