Electronics Lab Philippines

3D Printed Project

Offline cristeta

  • ****
  • 110
  • 8
  • Gender: Female
3D Printed Project
« on: April 12, 2019, 09:40:02 AM »
Hello po... Since uso at affordable na ang 3D Printer, nag bukas ako ng bagong thread .

Featured Project para sa Vinyl Record Enthusiast....

https://www.youtube.com/watch?v=R4wPfmGlOI8

Eto yung mga STL Files
https://pinshape.com/items/36877-3d-printed-vinyl-turntable-it-plays-records


Tetay :)

Offline Super zHero

  • *****
  • 5754
  • 310
  • Simple problem- ...simple solution.
Re: 3D Printed Project
« Reply #1 on: April 12, 2019, 11:04:29 AM »
Would  be nice if I still have my records :(

Offline danny

  • *****
  • 7651
  • 535
  • Gender: Male
Re: 3D Printed Project
« Reply #2 on: July 10, 2019, 10:03:46 PM »
madami pa din gumagamit ng vinyl dito
madami pa din akong ni rerepair na TT

nice project  :)

Offline motion55

  • *****
  • 3169
  • 520
  • Gender: Male
  • Been at this longer than you've been alive.
Re: 3D Printed Project
« Reply #3 on: August 14, 2019, 11:22:34 AM »
Electronic boxes for the 3D printer power supply:

Masyadong maingay ang original fan ng power supply. So tinggal ko ang cover at nilagay ko ang PSU sa isang malaking 3D printed box (almost the width ng printing area of the 3D printer) kasama ang IEC plug and switch. Then topped it with a very quiet 120mm fan.



The enclosure for the UPS is being printed next.

"Set your mind free!"

Offline rage3657

  • ******
  • 358
  • 23
  • Gender: Male
Re: 3D Printed Project
« Reply #4 on: August 26, 2019, 12:07:46 AM »

"Electronic boxes for the 3D printer power supply:"

Sir Motion anong filament material gamit mo jan?, pwede na kaya PLA sa mga electronic enclosure say up to 60 degC ang temp rating.


bong

Offline motion55

  • *****
  • 3169
  • 520
  • Gender: Male
  • Been at this longer than you've been alive.
Re: 3D Printed Project
« Reply #5 on: August 26, 2019, 07:51:14 PM »
PLA yan for evaluation at checking dimensions. So far walang issue. I'd rather see it melt and indicate overheating than not melt at mag overheat ang electronics.

In case matunaw, switch to PETG. However, may option to anneal PLA. Mas mataas ang temperature endurance. OK for small parts kasi nag shrink sa annealing process (boiling water). Example is the corner bracket for the glass build plate. PLA yan. Asul pero namuti after pinakulo.

"Set your mind free!"

Offline rage3657

  • ******
  • 358
  • 23
  • Gender: Male
Re: 3D Printed Project
« Reply #6 on: July 10, 2020, 09:26:51 PM »
My networked power outlets project with 3d printed box. hoping to inspire.

https://www.youtube.com/watch?v=9pD-Syxui6g
bong